One cable slipping off its drum groove is enough to jam a door mid-cycle or send a panel crashing at an angle. We fix the cable and check why it slipped in the first place.
Matching wear on both cables means both get inspected and typically replaced together.
Cable replacement without a drum check is an incomplete repair, so we always look at both.
Our technicians are trained to safely release and reset tension when cables are involved, not just the springs.
Cable stock in standard gauges means most replacements happen in a single visit.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
We replace the snapped cable and its pair, then verify even tension across both sides.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
Tell us if the door is hanging crooked or jammed, that detail helps us prioritize the call correctly.
Cable stock on the truck means most calls avoid a second trip for parts.
Diagnosis includes the drums, not just the visible cable, before any price is confirmed.
We verify the door hangs and travels evenly before calling the repair complete.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Same-day fix on a Saturday, cable stock right there on the truck.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
Both cables typically get replaced together to avoid a near-term repeat call.
We treat cable failures as priority calls given the safety risk involved.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
Pricing depends on cable length, gauge, and whether the drums also need replacing, confirmed as a flat number before work starts.
A snapped-cable call usually resolves in under two hours on-site.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591Technicians are positioned throughout San Saba for fast response, and we cover the surrounding zip codes too.
Embedded Map Placeholder for San Saba, TX